Ndfeb magnet production process one: melting. Smelting is the process of producing sintered NdFeb magnets. The smelting furnace produces alloy strip. The process needs the furnace temperature to reach about 1300 degrees and lasts for 4 hours to complete. After this process, the raw material for the magnets is hot-melted and cooled into alloy sheets before the next process, hydrogen crushing, takes place. The melting part is done after batching, the process of casting the prepared material into sheets or ingots, by large and small furnaces respectively.
In the following, neodymium magnet manufacturers will analyze and explain the precautions for casting parts melting:1. In the smelting process of neodymium magnet production, the instruments, things and auxiliary materials required are basically the same, such as gloves, masks and lighting supplies. Compared with this, the process of ingot casting is messy, casting should pay attention to wear, so as to avoid injury;2. Secondly, when hoisting, carefully check the equipment such as wire rope, which is required to be carried out in no man's land;3. Pay more attention to abnormal phenomena when pouring, so that the abnormal phenomenon can be sustained;4. Wear a mask when changing the tunder, so as to reduce the damage of dust to human body, avoid the contamination of casting by human body, and prevent casting from scratching human body.
